Plywood is mainly made of wood. Because of its rationality of structure and fine processing in production process, the defects of wood can be largely overcome and the physical and mechanical properties of wood can be greatly improved. Plywood production is an important method to make full use of wood and improve wood properties.

In the production of plywood, many varieties of patterns have been derived. One of the most important is to paste a thin layer of decorative veneer veneer on the surface of the original plywood, which is called decorative veneer veneer plywood. It is referred to as decorative veneer or decorative veneer in the market for short.

It is noteworthy that common veneer panels are divided into natural veneer panels and artificial veneer panels. Natural veneer panels are made of precious natural wood, veneer veneer by planing or rotary cutting. Artificial veneer panels are made of low-cost logs by rotary cutting, pressed by a certain process glue, and then shaved into decorative veneer with beautiful patterns. Wood.

Usually the veneer veneer of natural wood veneer veneer is usually well-patterned, high-value tree species, such as cypress, oak, rosewood, Fraxinus mandshurica, etc., but it should be explained in the name of the commodity, such as "cypress veneer plywood", or "Fraxinus mandshurica slice plywood", or "cherry veneer", in several ways of calling "veneer", "slice", "fraxinus mandshurica" and "fraxinus mandshurica". "Decoration board" reflects the basic characteristics of "Decoration board", but can not be abbreviated as cypress triplywood, Manchurian ash triplywood, etc., because these abbreviations refer to the panels and boards of fan-finger plywood are made of cypress or Manchurian ash.